GLIND Splitter Valve with fittings and clamps

Description

May 2023 – Back in stock due to popular demand

All prices shown are GST inclusive

Add a splitter valve to your GLIND hot shower to allow recirculating of on-board water while you drive.

This creates a heat on the run system where you can turn 1 arm of the valve on to recirculate your onboard water to have a supply of heated water, while the branch to the shower outlet is turned off.

The Splitter Valve has 2 branches which can be independently adjusted.

To avoid any pump overload, the general rule of thumb is to work on heating the supply water at a rate of 6 minutes per 20lt of water while driving.

When driving and the vehicle is under load, the engine is providing the maximum coolant flow and this makes heating water extremely efficient.

So, if you have a 60lt water tank, run the pump for 20 minutes and this will be sufficient to heat your supply to approx. 50°C (all vehicles have different efficiency rates, so some initial trial and setup is required to find the cycle best suited to your personal vehicle).

Water pumps are not continuous, so turn your pump off, it has done its work.

The fittings supplied with the Splitter Valve are high temperature Ny-glass, and Stainless Steel Hose Clamps.

When you arrive at camp, simply turn the tank branch of the valve off, and turn on the branch which goes to the shower outlet.

You’ll have a warm shower ready to go and 1 happy wife